On Vigor3300 VPN, where/how do we set the remote and local IPSec identifier?
Posted by Gabriel Yu on 12 May 2008 06:15 AM
The "Local ID" field is used for IPSec Aggressive mode which is not supported on 3300 series; so the Vigor 3300V don't have "Local ID" field. |
There are two cases.
- Â Aggressive mode is used in IPSec IKE phase 1. Currently, 3300 doesn't support aggresive mode, but you may use main mode to establish the VPN
- Main mode is used in IPSec IKE phase 1. In this case, you can use IP address instead of ID.
If other endpoint's WAN IP is fixed, please input it in the Remote Gateway.
If other endpoint's WAN IP is dynamic, please input it's DNS name or just input 0.0.0.0 in Remote Gateway.
Please refer to following links: