Knowledgebase: IPTV
How to setup TPG IPTV on Vigor27xx series routers
Posted by on 28 November 2011 01:41 PM

This FAQ will apply for both the Vigor2700 [G][V][VG] and the 2700 [e][Ge]

Procedure STEP-BY-STEP

  1. Open your browser and enter 192.168.1.1 in your address bar
  2. Enter the username and password of your router. By default it will be Username: "admin" and Password: (leave as blank) or if you have changed this, please enter the new username and password
  3. Click on "Internet Access" on the left side menu then click on "Multi-PVCs"
  4. Enable Channel 3
  5. In the VPI field type in "0"
  6. In the VCI field type in "35"
  7. Select the QoS Type to "UBR"
  8. Select the Protocol to "MPoA"
  9. Select the Encapsulation to "1483 Bridged IP LLC"
  10. Click "Ok" to save the configuration

 Application

 

11.  Select "Port-based Bridge" page

12.  Enable Channel 3

13.  Tick P2~P4. Enable the port (P2, P3 or P4) only if the PC is going to  connect TPG IPTV

14.  In Service Type, select "IGMP"

15.  Click "OK"

 Application

 

16.  Click on "Applications" on the left side menu then click on "IGMP"

17.  Tick the "Enable IGMP Proxy"

18.  Tick the "Enable IGMP Snooping"

19.  Click "OK" to save the configuration

 

Application

16.  Telnet to the router and enter the following command:

ip igmp_snoop txquery on

 

Application

IPTV over Wireless Connections

The Vigor2700 [G][VG]  router also supports IPTV over the wireless network.

Select the required wireless SSID in “Multi PVCs >>Port based bridge” configuration menu in addition to the settings described above to set up the router for IPTV.

 

Application

 

 

(2 vote(s))
Helpful
Not helpful

Comments (0)