How to Change LAN port Settings in Vigor3300 Router
Posted by Roy Panetta on 28 November 2011 04:08 PM

This function is available from firmware version 2.6.2 and above and is only available in the Command Line Interface of the router.    

Telnet to the router and run the “switchport” command. This is available in the network configuration option.

The syntax for this command is:

Full Name:  Set switchport function

Description:

Syntax:

   switchport -s

   switchport <Port> <Mode> <Auto>

 Parameters:

      <Port>            1-4

      <Mode>            1: Auto ; 2: 100/F ; 3: 100/H ; 4: 10/F ; 5: 10/H

      <Auto>            0: Manual ; 1: Auto

 

 

For example to configure LAN port 1 to 100Mb full duplex use the following command:

Switchport 1 2 0 [Enter]

Picture-1

 

For other Draytek models,

On the telnet command,

>Port <1,2,3,4> <AN,100F,100H,10F,10H,status>

 

 

 

 

 

 

(0 vote(s))
Helpful
Not helpful

Comments (0)