Knowledgebase
Configure Vigor Router to only allow RDP access from one Source IP
Posted by Roy Panetta on 12 December 2011 01:40 PM

In this example we will configure the Vigor2820 to only allows RDP access to a PC on the LAN from one IP address on the Internet.

Step1: Block all RDP access from the Internet

Go to Firewall>>Filter Setup and edit Filter set 2 rule 2

Picture-1

Select direction WAN ->WAN

Source IP: Any

Destination IP: Enter Any to block RDP to all devices or enter IP address if blocking access to a single PC.

Service Type: Enter TCP, Port from any to 3389. (We do not know the source incoming port that will be used).

Action: Block Immediately or Block if no Further Match.

Picture-2

Step2: Allow RDP access from the Internet to required PC

Picture-3

(5 vote(s))
Helpful
Not helpful

Comments (0)