Knowledgebase: Internet Access (WAN)
How do I change the MTU size of the router?
Posted by on 12 December 2011 04:30 PM

Accessing Telnet

Click Start > Run and type Telnet 192.168.1.1 in the Open box as below. Note that the IP

address in the example is the default address of the router. If you have changed the default,

enter the current IP address of the router.

Internet Access

Click OK. The Telnet terminal will be open. If an administrator password has not already been assigned, follow the on-screen instructions to assign one.

Internet Access

After assigning a password, type . You will see a list of valid/common commands depending

on the router that you use.

Internet Access

  

Type the command: wan ppp_mss then press ENTER (the current MTU size will display)

To change the MTU size type : wan ppp_mss 1500 then press ENTER (Note that 1500 is the MTU size).                

Internet Access 

  

Check the new MTU size by typing wan ppp_mss then press ENTER.

 

Further Information

wan ppp_mss

This command allows you to adjust the parameters for TCP protocol, MSS (maximum section size) for WAN side. The more the size is, the more the packets of payload will be.

 

wan ppp_mss [MSS size]

Syntax Description

MSS size It means to set suitable size for MSS. The available range for this

setting is 1000 to 1500.

Example

> wan ppp_mss 1442

 

(0 vote(s))
Helpful
Not helpful

Comments (0)