Knowledgebase: Getting Started
Getting Started
Posted by Roy Panetta on 14 December 2011 03:40 PM

Installing Router Hardware

ADSL Models

Before starting to configure the router, you have to connect your devices correctly.

1. Connect the DSL interface to the external ADSL splitter with an ADSL line cable.

2. Connect one port of 4-port switch to your computer with a RJ-45 cable.

3. Connect the power

4. Connect the telephone sets to FXS1 or FXS2 ports if required (VoIP function on V models).

5. Power on the router.

6. Check the ACT LED to assure network connections.

Caution: Each of the FXS ports can be connected to an analog phone only. Do not connect the FXS ports to the telephone wall jack. This connection might damage your router

Picture-1

Dual WAN Models

Before starting to configure the router, you have to connect your devices correctly.

1. Connect External Cable/DSL modem to the WAN port with an Ethernet cable

2. Connect one port of 4-port switch to your computer with a RJ-45 cable.

3. Connect the power

4. Connect the telephone sets to FXS1 or FXS2 ports if required (VoIP function on V models).

5. Power on the router.

6. Check the ACT LED to assure network connections.

Caution: Each of the FXS ports can be connected to an analogue phone only. Do not connect the FXS ports to the telephone wall jack. This connection might damage your router

Picture-2

Computer Settings

Configure the PC to use DHCP to obtain an IP number from the router.

If the DHCP setting does not work, then set a Static IP address for the network card in your PC as shown in the Manual setting.

Picture-3

 

Connecting to The Router Web Interface

 

Using a web browser (Internet Explorer , Mozilla etc) connect to the router (Default IP number 192.168.1.1). If the default router IP number has been changed, use the new IP number.

Picture-4

Once connecting to the router web interface, you will be prompted for the Username and Password. Enter the username admin and there is no password. If the username or password were changed, then use these new values.

Picture-5

NOTE: For later model routers 

default Username: admin

Password:  admin

Picture-6

Opening Screen after logging into the router.

(0 vote(s))
Helpful
Not helpful

Comments (0)