Knowledgebase: VPN and Remote Access
Why I Cannot establish L2TP over IPSec tunnel successfully?
Posted by on 27 January 2012 01:48 PM

Please check your network setup by following these procedures:

  1. Does either VPN client (e.g. WinXP on PC) or VPN server (e.g. Vigor 2910 ) connect to the internet through a NAT device?


     
  2. If you are remote dial-in user and use DrayTek "Smart VPN Client" utility, please be sure to click the "Configure" button in Step 0 of the setup.

     http://www.draycavre.com.au/dfaq/image/VPN/13/vpn_45.JPG
  3. Check that the IPSec service status is active from Start -› Settings -› Control Panel -› Administrative Tools -› Services. If not, "Start" IPSec Service and establish L2TP over IPSec VPN tunnel again.
     http://www.draycare.com.au/dfaq/image/VPN/13/vpn_46.JPG 
(0 vote(s))
Helpful
Not helpful

Comments (0)