Knowledgebase: VPN and Remote Access
How to configure L2TP on IPhone and 2910 with 3.2.4_RC5 firmware
Posted by on 14 February 2012 02:47 PM
These are the only settings required
 Vigor 2910 settings
http://www.draycare.com.au/dfaq/image/VPN/16/vpn_55.JPG
The Pre-Shared Key (above) is the character string that you need to enter in to the ‘Secret’ field of the iPhone L2TP setup (see below). In order to get a connection, the iPhone needs to know the Dial-in user’s Username, the Dial-in User’s Password, and the IPsec Pre-Shared Key.
And the following is the remote user settings….
http://www.draycare.com.au/dfaq/image/VPN/16/vpn_56.JPG
iPhone settings
Go to settings → VPN
http://www.draycare.com.au/dfaq/image/VPN/16/vpn_57.JPG



The server is the IP address or domain name of the 2910
The Account is the ‘Remote Dial-in User’ Username on the 2910
The Password is the password defined in the ‘Remote Dial-un User’ account name password field on the 2910
The Secret is the ‘Pre-Shared Key’ that was entered on the ‘IPsec General Setup’ on the 2910
(1 vote(s))
Helpful
Not helpful

Comments (0)