Knowledgebase: Internet Access (WAN)
Vigor2830 WAN Failover Configuration
Posted by on 15 February 2012 01:13 PM

In this example we Configure WAN1 (ADSL) as the primary WAN connection and have WAN2 to be the backup WAN.

 

Ensure WAN2 is selected as the backup WAN as shown in the diagram below

 

http://www.draycare.com.au/dfaq/image/Internet_Access/11/WAN_42.JPG

 

General setup Page should look as shown below:

 http://www.draycare.com.au/dfaq/image/Internet_Access/11/WAN_43.JPG

Note: When WAN 1 fails (No ADSL sync) It will take about 10 seconds for WAN2 to come up.

(0 vote(s))
Helpful
Not helpful

Comments (0)