Knowledgebase
ap800 wds procedure
Posted by on 15 February 2012 01:56 PM

Set up the main router

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_39.JPG

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_40.JPG

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_41.JPG

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_42.JPG

 

Search for the AP800 on tha Wireless LAN>> Access Point Discovery select repeater then click add.

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_43.JPG

You can see now that the AP800 is added to the WDS setting of the 2710.

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_44.JPG

 On the AP800 select AP Bridge-WDS

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_45.JPG

Change the IP of the AP800 to match with the IP subnet of the main router so you can easily access it if you want to change anything.

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_46.JPG

Go to Wireless LAN Access Point Discovery and select the main routers SSID then click add.

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_47.JPG

You will see on Wireless LAN >> General settings that the main router is now added on the Phy Mode.

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_48.JPG

 

You can see if there is a successful connection on the main router. Just go to Wielress LAN>> WDS setting then Click Link Status.

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_49.JPG

The link is now active.

 http://www.draycare.com.au/dfaq/image/WLAN/14/WLAN_50.JPG

(4 vote(s))
Helpful
Not helpful

Comments (0)