Vigor2960 Series Bigpond 3G Setup
Posted by Roy Panetta on 28 February 2013 03:58 PM
In this guide we will show you how to configure the Vigor2960 for 3G/4G backup connection.
Note: The router will need to have firmware version 1.0.7 or later to support the 3G modem
We will have WAN1 as the primary WAN connection and configure USB1 (3G USB Modem) as the backup WAN connection.
STEP 1: Configure USB Port
In web browser (IE , Firefox, Chrome etc) access the menu page of Vigor2960 router (default IP address is http://192.168.1.1)
Once you have logged in, go to “WAN>>General Setup “ menu. Select the USB WAN tab.
Highlight USB1 and click on Edit.
In the USB WAN menu, select “Enable” and select 3G for Protocol setting.
Select USB 3G tab and enter the required details (APN name, Username and password if required)
Click on Apply to save the settings and return to previous menu
STEP 2: Configure WAN Failover
Go to “WAN>>Load Balance “ menu. Select the Pool tab.
Click on “Add”
Now select Mode tab. Enter a Profile name and select Failover for Mode.
Select Failover Tab.
Select Wan1 for Primary Profile
Select usb1 for Backup Profile
Click Apply to save.
STEP 3: Configure Default Route
Go to “WAN>>Default Route “ menu. Select the Failover profile we created in the last step.
Click on “Apply” to save
STEP 4: Check 3G/4G Modem Connected
Go to “Online Status“ menu and check that USB1 is up when WAN1 goes down.