Knowledgebase
Configuring Vigor2760 Delight for Ethernet WAN Connection
Posted by Roy Panetta on 17 December 2014 05:00 PM

In this guide we will show you how to configure the Vigor2760 Delight router to use LAN port 4 as an Ethernet WAN interface to allow the router to be connected to a broadband service such as the NBN. The router will need to be running the latest firmware for this feature to be available.

2760 Rear Panel

 

Step 1

 

Go to WAN >> General Setup configuration menu. Select WAN2.

WAN2

You will notice the message on this page it states that when WAN2 is activated, LAN port 4 will become WAN 2.

Step 2

Enable WAN2 and select the Physical Type if required to match the device it will be connected to.

WAN2

Click OK to save.

The router will reboot to save the settings.

Router reboot

Step 3

Go to WAN >> Internet Access configuration menu.

For WAN2 select the required Access Mode. For our example we will select Static or Dynamic IP.

Click on Details Page to complete the configuration of WAN 2

Internet Access

Step 4

Configure WAN2 details.

For our example we will use DHCP. So all we need to do is select Enable and also select  Obtain an IP address automatically as shown below.

Now click OK to save the configuration.

WAN2 Configuration

The router will reboot to save the WAN configuration changes.

 Router reboot

Step 5

Connect LAN port 4 of the router to the Internet service (e.g. NBN connection)

Go to Online Status>>Online Status menu and check that WAN2 is now active.

Online Status

 

 

 

(2 vote(s))
Helpful
Not helpful

Comments (0)