Knowledgebase
Configuring Vigor2760 Delight for iiNet NBN Connection
Posted by Roy Panetta on 09 April 2015 04:15 PM

This guide we will show you how to configure the Vigor2760 Delight router to connect to iiNet NBN connection. The first step is to configure LAN port 4 to become an Ethernet WAN interface to allow the router to be connected iiNet NBN. The router will need to be running the latest firmware for this feature to be available.

Note: This guide only applies to iiNet NBN and may not apply to other NBN providers. You will need to check with the NBN provider for the configuration parameters required in steps 2.

Step 1:  Configure LAN 4 to become a WAN Interface

2760

 

Step 1.1

Log in to the router’s Admin page.  If the router is at factory default settings use the following:

Use your internet browser then enter 192.168.1.1.

Enter Username: admin

Enter Password: admin

2760

Step 1.2

Go to WAN >> General Setup configuration menu. Select WAN2.

You will notice the message on this page that states that when WAN2 is activated, LAN port 4 will become WAN 2.

 

2760

Step 1.3

Enable WAN2 and select the Physical Type if required to match the device it will be connected to.

2760

Click OK to save.

The router will reboot to save the settings.

2760

Step 2: Configuration for iiNet NBN

After the router has restarted log into the router again.

Step 2.1

Go to WAN>>General Setup configuration menu and select WAN2.

2760

Step 2.2

Check that you have the settings as shown in the diagram below. They should be similar to those set up in step 1.

  1. Select Yes for Enable option.
  2. Leave Physical Type at the default value “Auto negotiation”
  3. VLAN Tag insertion set to “Disable”
  4. Click OK to save the settings.

2760

Step 2.3

Go to WAN >> Internet Access configuration menu.

For WAN2 Access mode select Static or Dynamic IP.

Click on Details Page to complete the configuration of WAN 2

2760

Step 2.4

Configure WAN2 Static or Dynamic IP details.

  1. Select “Enable

  2. Select “Obtain an IP address automatically

2760

The router will now restart.

Step 2.5

After the router has restarted log into the router again to check your NBN connection status.

Go to Online Status>>Physical Connection menu

If you see WAN 2 is all green it means your NBN connection is working.

2760

 

(2 vote(s))
Helpful
Not helpful

Comments (0)