How to Connect a DrayTek Vigor300B router to DODO NBN
Posted by on 01 May 2015 02:24 PM
This guide will show you how to configure a DrayTek Vigor300B router to DoDo NBN connection.
Step 1 - Connect to the router Admin page
Using your internet browser go to 192.168.1.1.
User name: admin
Step 2 – Configure WAN>> General Setup
a. Go to WAN>> General Setup configuration menu and select WAN1.
Note: DoDo NBN requires data packets to be tagged with a VLAN ID of 100, so you will need to enter this into the WAN settings. Otherwise you will not be able to access the Internet.
b. Select Yes for Enable option.
c. Select Enable for VLAN Tag.
d. Enter the value 100 for VLAN ID.
e. Select PPPoE for IPv4 Protocol.
Step 3 – PPPoE
a. Select PPPoE
b. Enter the Username and Password supplied by DoDo.
c. Click Apply to save the settings.
Step 4 – Check the router is connected to DoDo NBN
a. Go to Online Status.
b. Check that WAN 1 status indicates that the router is now connected.
You should see “Connection” as “up” and IP addresses displayed similar to the screen shot below. You can now access the Internet through the Vigor300B router.