Knowledgebase: Vigor2912
How to Connect a DrayTek Vigor2912 router to TPG NBN
Posted by Jordan Dicesare on 29 September 2016 02:27 PM

How to Connect a DrayTek Vigor2912 router to TPG NBN

This guide will show you how to configure the DrayTek Vigor2912 router to TPG NBN connection. TPG requires a username and password to authenticate the connection so we will use PPPoE for authentication.

Step 1 - Connect to the router Admin page

Using your internet browser go to 192.168.1.1.

User name: admin

Password: admin

Log into your router

 

 

Step 2 – Configure WAN>> General Setup

Go to WAN>> General Setup configuration menu and ensure WAN1 is enabled.

Click on WAN1

 

Step 3 – Configure WAN>>Internet Access

a. Go to WAN>>Internet Access configuration menu.
b. For WAN1 select PPPoE for Access mode.
c. Click Details Page tab.

Set WAN1's access mode to PPPoE and then click on the "Details Page"

 

d. Enter the Username and Password supplied by TPG.
e. Select Enable for PPPoE Link.
f. Click OK to save the settings

Sign in with your TPG username and password

 

g. Click OK and then you will be prompt with a Reboot System request.

Do as it says

 

h. Make sure Using current configuration is ticked and then click OK.
i. Then wait 10 seconds as directed by the following prompt, then click on the link provided to be brought back to the long in page.

click either link after waiting 10 seconds

 

Step 4 – Check the router is connected to TPG NBN

Log in into the router once the router has restarted.

a. Go to Online Status>>Physical Connection and check the status of WAN1 indicating that the router is now connected.

You should have a similar screen to the one below. You can now access the Internet through the Vigor2912 router.


check that WAN1 is working

 

Speed test results

speed test results

 

 

 

(0 vote(s))
Helpful
Not helpful

Comments (0)