Knowledgebase
How to Connect a DrayTek Vigor3900 router to TPG NBN
Posted by Jordan Dicesare on 06 October 2016 09:19 AM

How to Connect a DrayTek Vigor3900 router to TPG NBN

 

This guide will show you how to configure the DrayTek Vigor3900 router to TPG NBN connection. TPG requires a username and password to authenticate the connection so we will use PPPoE for authentication.

Step 1 - Connect to the router Admin page
Using your internet browser go to 192.168.1.1.

User name: admin

Password: admin
Log into your router

 

Step 2 – Configuring WAN

a. Go to WAN>> General Setup and on the General Setup tab, ensure wan1 is enabled.
Ensure wan1 is enabled

 

b. If it isn’t allready enabled, double click on wan1 (may take 1 to 3 seconds to appear) or click the Edit button with wan1 selected to bring up its menu and tick the enable box.
Tick the box

 

 

Step 3 – Setting PPPoE       
a. Go to WAN>> General Setup and double click on wan1 to bring up the General Setup menu. (may take 1 to 3 seconds to appear) Or simply click Edit once wan1 has been clicked on.     
b. Click the drop down box next to IPV4 Protocol: and then change it to PPPoE.
c. Then click on the PPPoE tab.
Select PPPoE from the drop down box

 

d. Enter the Username and Password supplied by TPG.
e. Click Apply to save the settings.
sign in with your TPG account

 

f. This pop up will appear notifying you that the change will take effect after a while or approximately 1 to 3 minutes.
Click OK

Step 4 – Check the router is connected to TPG NBN

Login into the router once the router has restarted.

a. Go to Online Status menu which should appear on start up.
b. Check that wan1 status indicates that the router is now connected.

You should have a similar screen to the one below. You can now access the Internet through the Vigor3900 router.

See that wan1 is working now

 

 Speed Test Results
Speed test reults

 

 

(1 vote(s))
Helpful
Not helpful

Comments (0)