How to Setup TPG IPTV on Vigor2860
Posted by Edward Eroy on 12 October 2016 09:54 AM
This application note describes how to configure the DrayTek Vigor2860 router to access IPTV supplied by TPG were using the 126.96.36.199 firmware version.
The firmware is available in this link:
Log into the router and go to WAN >> Multi-PVC/VLAN configuration menu.
Select WAN5 as highlighted below:
A.) Enable Multi-PVC/VLAN Channel 5 and select WAN Type ADSL
B.) Under General Settings enter the following values:
Encapsulation 1483 Bridged IP LLC
C.) Enable Open Port-based Bridge Connection for this Channel and select the LAN ports to receive IPTV. (Port 1 is reserved and cannot be selected)
D.) Tick Open WAN Interface for this Channel and select WAN Application as IPTV.
E.) Enable Obtain an IP address automatically then click “OK” on the bottom page.
Go to Applications >> IGMP configuration menu. Tick Enable IGMP Proxy then click “OK”.
Once the Group ID appears, it indicates that the router has successfully obtained IP address servers for IPTV TPG
How to Play IPTV TPG using VLC Player
The links below provide information on how to use VLC player to watch IPTV