Knowledgebase: Internet Access (WAN)
Configuring Vigor130 for VDSL Bridge mode
Posted by Roy Panetta on 25 October 2016 03:57 PM

Before you start, ensure the Vigor130 has the correct firmware installed that supports NBN VDSL2 connection. Click here for more details.
If required you may need to configure the VLAN ID (only if required by your ISP)

Configuring Bridge Mode

 Go to "Internet Access >> MPoA / Static or dynamic IP" configuration menu
2. Select "Enable"
3. On the bottom left (Bridge Mode selection), enable the "Enable Bridge Mode"
4. Click OK to save
5. Device will reboot

DV130

Note: Once the DV130 configured to bridge mode, the DHCP server on DV130 will not function. If you need to configure the device, you will need to configure your PC to have a static IP address 192.168.1.x subnet (for ex. 192.168.1.100).

 Click here to watch the video.

(6 vote(s))
Helpful
Not helpful

Comments (0)