Knowledgebase: Internet Access (WAN)
Configuring Vigor2760 for VDSL Bridge mode
Posted by Roy Panetta on 25 October 2016 04:02 PM

Before you start, ensure the Vigor2760 has the correct firmware installed that supports NBN VDSL2 connection. Click here for more details.
If required you may need to configure the VLAN ID (only if required by your ISP)

Configuring Bridge Mode

1. Go to "Internet Access >> MPoA / Static or dynamic IP" configuration menu

For routers running older firmware you will need to first select “Obtain an IP address automatically” shown in step 1 before you enable bridge mode.

Note: Selections must be done in this same order otherwise you will get an error message “Invalid IP” and cannot save settings. This bug has been rectified in new firmware released after November 2016


2.  Select "Enable"
3. On the bottom left (Bridge Mode selection), enable the "Enable Bridge Mode"
4. Click OK to save

dv2760

 

 

(4 vote(s))
Helpful
Not helpful

Comments (0)