Knowledgebase: Vigor2960
How to Enable WAN Aggregation on DrayTek Routers
Posted by Edward Eroy on 27 October 2016 03:26 PM

WAN Aggregation is a feature introduced into DrayTek routers to aggregate multiple WAN connections to provide higher speed to the Internet by utilizing the “Session Based” load balance mode. This feature is available in the DrayOS routers Vigor2860, Vigor2912, Vigor2920, Vigor2925, Vigor2952, Vigor3200 and Vigor3220 as well as in the Linux-based routers Vigor2960, and Vigor3900. This application note will go through the steps for each router operating system.

A description of the WAN aggregation feature is available in the Blog article:

http://www.draytek.com.au/how-to-double-your-internet-speed/

 

 

Routers Running DrayOS Operating System

This section applies to Vigor2860, Vigor2912, Vigor2920, Vigor2925, Vigor2952, Vigor3200 and Vigor3220 routers.

These routers will need to be running the latest firmware for this feature to be available.

 

Go to WAN >> General Setup configuration menu.

For Load Balance Mode select Session Based option.

Click OK to apply to save the settings

 

Routers Running Linux Operating System

This section applies to the Vigor2960, Vigor300B and Vigor3900 routers.

Routers will need to run firmware version 1.2.1 and above.

 

Go to Routing >> Default Route configuration menu.

For Load Balance Mode:  select Session Based

Click Apply to save the configuration.

 

(5 vote(s))
Helpful
Not helpful

Comments (0)