How to configure LAN to LAN VPN Tunnel to Route all Internet Traffic to Private Internet Access (PIA)
Posted by Edward Eroy on 24 May 2017 11:35 AM
This application note describes how to route all internet traffic via the Private Internet Access (PIA) VPN service using LAN to LAN VPN tunnel configuration. This configuration applies to DrayOS routers (DV2760, DV2912, DV2860, DV2925, DV2952, and DV3220)
Supported VPN tunnel modes are PPTP and L2TP. PPTP provides encryption for extra security and is also faster than L2TP which does not encrypt the data.
Access your Private internet access account under PPTP/L2TP/SOCK Username and Password click “Regenerate Username and Password”.
Step 2: Configure DrayTek Router
VPN and Remote Access >> LAN to LAN
Enable the VPN Profile set the call direction to Dial-Out and select Always on.
In the Dial-Out Settings Select either PPTP or L2TP ”None”, apply the generated username and password from the PIA account and input the Server IP/Hos Name for VPN “aus.privateinternetaccess.com”
TCP/IP Network Settings
select NAT and enable Change default route to this VPN tunnel
VPN and Remote Access >> Connection Management
Click Dial VPN profile
L2TP Mode: Data is not encrypted
PPTP Mode: Data is encrypted
For improved DNS query response time change the preferred DNS server to the PIA: 18.104.22.168 and 22.214.171.124 as shown below.