RSS Feed
Knowledgebase : System Maintenance / Troubleshooting > Telnet
You can change the hostname via a command in the telnet interface of the router. Firstly, to telnet into the router Once in the command prompt, type in the command: sys name <hostname> e.g. sys name vigor2700Ge will change the hostname to vigo...
Telnet is one of the old DOS commands still supported by Windows, but without a Windows graphical interface. From the Windows' Start menu, select "Run ..." and enter "telnet 192.168.1.1" (as shown below) and click OK. A Command Prompt window will open, ...
QUESTION Is there a CLI command list for the Vigor2820 router? ANSWER There is Telnet documentation listing the CLI commands. It is available at: HTTP://WWW.DRAYTEK.COM.AU/DOWNLOADS.PHP [http://www.draytek.com.au/downloads.php]. This gives the CLI c...
Telnet is one of the old DOS commands still supported by Windows, but without a Windows graphical interface. From the windows' Start menu Click Start > Run and enter TELNET 192.168.1.1 (as shown below) and click OK. NOTE: The IP address in the example...
telnet to the router and type the command: >sys tr log
This document is based on the telnet commands for the Vigor2862 Series Firmware Version: V3.8.8. Other routers may have a subset of the telnet commands listed here. Click HERE [HTTP://WWW.I-LAN.NET.AU/DFAQ/DRAYTEK/MISC/DRAYTEK_TELNET%20COMMANDS%20V1.4.P...