RSS Feed
News
Jul
21
Posted by Roy Panetta on 21 July 2017 01:47 PM

New Application Notes

VPN

Vigor Router to Vigor Router – PPTP

This document shows how to establish a PPTP LAN-to-LAN VPN between two Vigor Routers.

Click here to read the application note.

IPsec Tunnel between two Vigor Routers with the same IP subnet

This document shows how to create an IPsec LAN to LAN VPN between the two offices where both routers have the same LAN IP subnet. It uses the Virtual IP mapping feature  in the “IPsec VPN with the Same Subnets” setting option available in the latest firmware for Vigor2860 and Vigor2925 routers.

Click here to read the application note.

Vigor Router to Vigor Router - L2TP over IPsec

This application note shows how to establish a L2TP over IPsec VPN tunnel between two Vigor Routers.

Click here to read the application note.

Application

What is High Availability?

This updated application note gives an overview of High Availability and how it works. It also explains the differences between Hot-Standby and Active-Standby modes.

Click here to read the application note.

WAN

[Vigor3900] How to use Virtual WAN in bridge mode?

This application note shows how to set up Bridge WAN for IPTV on the Vigor3900 and Vigor2960 routers.

Click here to read the application note.

Central AP Management

[Vigor3900] How to provision a VigorAP by AP Management (APM)?

This application note describes how to provision VigorAP’s using the AP Management (APM) feature on Vigor3900/2960/300B routers.

Click here to read the application note.

 

Firmware Updates

Vigor Manager for iOS V1.1.2

This new version includes some bug fixes.

Click here to download

 

Vigor2860/Vigor2860L V3.8.4.6

New feature:

  •          Support BGP.

Improvement

  •          WAN1 increased timeout during LCP Terminate-ACK.
  •          IPsec traffic wasn't passed to VPN server at Vigor2860 routing subnet.
  •          DDNS update problem occurred when 3G modem, PPP mode was used. 

Click here to download

 

Vigor2760 Delight V3.8.2.3

  New feature:

  •          Support VigorACS 2.0.

Improvement

  •          Add an option to Disable TLS 1.0.
  •          Add telnet command for configuring VPN Dial-out through.
  •          Add a new option "MS-CHAPv2 Only" for Dial-In PPP Authentication.
  •          LAN client could access Vigor router across VLAN.
  •          NAT loopback did not work when DMZ was enabled.
  •          Ping Diagnosis of diagnostics interface was displayed incorrectly when ping through VPN tunnel.

Click here to download

 

Vigor2960 V1.3.1

New Feature:

  •          Add Fast Route function to reduce CPU loading (Routing>>Fast Route).

Improvements

  •          Improvements to make security updates for Samba service (CVE-2017-7494).
  •          Update SSH server to new version (2016.74).
  •          Update APP signatures for Hotspot, UltraSurf, PPstream and Google Hangouts.

For a complete list of improvements, refer to the release notes in the download link below.

Click here to download

To subscribe to our regular news updates click on “Subscribe” on this page or login into your i-helpdesk account and enable the “Subscribe” option.
If you no longer wish to receive e-mails from us, please reply with "Unsubscribe".
For more information on i-Lan Technology Pty visit http://www.i-lan.com.au/support/terms-conditions or email support@i-lan.com.au if you have a specific question that you would like addressed.

 


Comments (0)